DKU 5 USB TO SERIAL CABLE DRIVER

That being said, all of the serdes operation of the USB port is done in hardware, so hacking it at the driver level isn't going to work well. Et voila, it works! The power of activism should never be underestimated. When I opened the "little plastic box" that contains the level converter PCB, all the pinouts were clearly marked. Hi again, The CA cable has some problems.. Check out his blog too, he posts some cool stuff.

Uploader:	JoJole
Date Added:	17 July 2006
File Size:	45.97 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	73632
Price:	Free* [*Free Regsitration Required]

I wrote the ucHobby article first and then moved it to my own blog sometime later. After you connect the cable to the Arduino you no longer need to use Hyperterminal. When attempting to program, the DTR pin does go low, but it stays low, keeping the Arduino in reset instead of actually resetting the Arduino.

Diy serial Cable with cheap phone us Says:.

If you hold the button too long Arduino will eventually give up and report that the programmer is unavailable. Came in through hackaday.

How Can you Make a USB to TTL cable for Sanguino?

The shell can also be put back together with little effort. The Auto-reset input can be ignored and capacitor C1 can be left off. That series capacitor should already be on your motherboard and yhe extruder board too. The following figure shows the connection chain: After you have started PuTTY, follow the steps in the screen shots below. Several places sell chips with a bootloader; Modern Device seems to give you the seriao deal. What a whining bunch they can be, huh?

I read the thread and it appears you discovered the problem was caused by a USB extension cable. Probing There are most likely several different manufacturers dkh these cables because the same model will have a different number and color of wires depending on who you buy it from.

The BiT Bang Theory. Click here to login.

Thus the Rx and Tx shown, are from the PC side of the serial adapter. So even though the cable puts out only 3.

Other chip versions may not be; Check their datasheets. Earlier in the article I mentioned that my cable had too extraneous wires. D, and it can only be programmed once.

Reason is your board will not serisl recognized if zerial return is sent and the ATMega does not do anything. The device configuration registers allow you to change settings like the VID, PID, serial number, and maximum power required i. Bluetooth HC06 module with Backplane 6 Pins.

How Can you Make a USB to TTL cable for Sanguino?

Just saw your post on the Arduino forums. To tryout any old data cables you have lying around to see if they are suitable, do the same trick with dmesg, and plug your cable in without a phone attached. Where as one which powers the logic drivers will show 3. July 20, A copy of it is available here: Or is there another way to make it?

November 12, December 19, at 1: So if you can get some from t'internet for 3ukp a pop do it. Thus a level shifter is needed.

January 25,